How to maintain the burner of an asphalt mixing station properly
分类:Company News 发布时间:2024-12-16 14:22:51
he burner, as a key component for drying and heating stone materials, has received extensive attention from users.

The burner, as a key component for drying and heating stone materials, has received extensive attention from users. In the current market where there are various types of fuels, inconsistent quality standards, and complex fuel sources, whether the burner can operate properly is a basic requirement for the majority of users. So, how can it be adjusted to a better state? During daily inspections and maintenance, the following major issues should be noted.

Pressure regulating valve

Regularly inspect the fuel pressure regulator or pressure reducing valve to ensure that the locking nuts on the adjustable bolts are clean and can be removed. If the surfaces of the screws or nuts are too dirty or rusty, the regulator valve needs to be repaired or replaced.

Oil pump

Regularly inspect the oil pump to ensure that the sealing device is in good condition and the internal pressure is stable. Replace any damaged or leaking sealing devices. When using hot oil, check that all oil pipes are well insulated.

Filter

The filter installed between the oil tank and the oil pump must be cleaned regularly and checked for excessive wear to ensure that the fuel flows smoothly from the oil tank to the oil pump and to reduce the possibility of potential component failures; the "Y" type filter on the burner should be cleaned frequently, especially when using heavy oil or residue oil, to prevent clogging of the fuel injector and valves; during operation, check the pressure gauge on the burner to see if it is within the normal range.

Pressure device

For burners that require compressed air, check the pressure device to see if it generates the required pressure within the burner. Also, clean all the filters on the supply pipeline and inspect the pipeline for any leaks.

Blower

Check whether the inlet protection device on the combustion and atomization air blower is correctly installed, and whether the blower housing is undamaged and free from leakage; Observe the operation of the blades. If the noise is too loud or there is vibration, adjust the blades to eliminate it; For the blower with belt wheel transmission, regularly lubricate the bearings and tighten the belt to ensure that the blower can generate the rated pressure; Clean and lubricate the connection points of the air valves, check if the operation is smooth, and replace the parts when there are obstacles in the operation; Measure whether the wind pressure meets the working requirements. If the wind pressure is too low, it will cause backfire, resulting in overheating of the front guide plate and the discharging plate in the combustion area; If the wind pressure is too high, it will cause excessive current and even the bag to be scorched.

Fuel injector

The fuel injectors should be cleaned regularly and the spark gap of the ignition electrodes (about 3mm) should be checked.

Flame detector

Regularly clean the flame detector (electronic eye) to ensure that the installation position is correct and the temperature is appropriate. Incorrect position and excessive temperature can lead to unstable photoelectric signals and even loss of ignition.